All ShrockWorks bumpers are designed with the foremost priority: FUNCTION & PERFORMANCE! The point of a stubby bumper is to protect what needs protection and to maximize your approach angle and let you get up and over rocks and obstacles.

Standard Features Include:
A removable SKID PLATE that wraps underneath is included as a std feature! This skid plate wraps far enough under that it will also protect the sway bar disconnect motor found on all JK Rubicon's and some other 2007+ Jeep JK's. Since the skid is removable, it can be easily replaced if damaged. That's not likely to happen though. The skid is formed specifically for strength. The edges are bent up on the sides. It has welded gussets on the back side, and it's made from the same high-tensile 3/16" steel plate as the bumper itself. This is probably the most damage-prone area on a Jeep. Many bumpers have a flimsy flat piece of flat plate in this area. One good hit there, and the whole bumper is bent & toast. Others charge you extra for a skid plate. We consider it a necessity and include it as a std. feature.

Shackle / Recovery points are included as a std feature. They are made from massive 1" thick plate steel. They are welded front & back, and they are designed in such a way that even if the welds were to fail, the recovery points themselves are still held in the bumper (see CAD pic)

• 3/16" plate steel bumper & skid plate
• 1" thick steel recovery points.
• 2" x .120" high strength tubing
• Bumper: 44 lbs.
• Winch Plate: 11 lbs.
• Skid Plate: 27 lbs.
• Total: 82 lbs.
• All new hardware included
• Bolt on, no drilling or cutting

What about the FACTORY FOG LIGHTS?

The factory fog lights are almost 5" deep. Some competitor's "Stubby" bumpers put these fog's in front of the winch. Those bumpers then hang out there FIVE INCHES further from the Jeep. That's a lot and will really effect where you can and can't go in your Jeep.

The other approach competitiors take is to put the lights under the winch and set the winch on top of the bumper, which blocks a lot of airflow to the radiator.

If you intent on keeping the factory fog's, looks at Shrockworks Mid-Width bumper. If you want fogs and driving lights with a Stubby, get the PIAA 525 dual mode fog and driving light.

Optional winch opening cover for a clean look w/o a winch. This plate will also accommodate an additional set of off-road lights on top of the bumper. A license plate will cover the fairlead opening.